Recent content by thaught

Anyone have one for sale?

30 mm and .87” height. Asking $100

thanks everyone. I watched the Eric Cortina video and used his method using scotch tape. The proper headspace on my rifle is 2.1850”. I will FL size the brass but will be careful not to bump the shoulder on this firing.

Yes, it chambers just fine

Hornsdy gauge

Have a new rifle I just built chambered in 30 Nosler. I started with new ADG brass and shot 50 rounds through it to break in and kind of get a start in load development. Most of the brass is coming back at 2.1835" after being shot, and 2 are coming back at 2.1850". Looking at my reamer print...

Looking for an ATACR with moar-t reticle.

My computer crashed and I’m having hell downloading quick load again and I’m looking for someone to run a few loads for me. I’m willing to send ya $20 for your trouble 30 Nosler, 23 inch barrel, fed 215m primer, Berger 215s, powder needed is N570, Retumbo, and H1000

First rifle is the Mesa model in 7 REM Mag. This rifle is like brand new and only has about 40 rounds down the tube. It shoots amazing with Nosler Trophy Grade 160 gr Accibonds. It shoots almost 1/2 moa with them. Comes with 20 moa base. Asking $1,000 Second rifle is CA Ridgeline model in 28...

I’ll take the 215s

Pm sent

I am looking for a proof CF barrel blank in .308” that is 22” long.

Yes, that with the bullet seated

The reamer spec shows the cartridge neck diameter at .3460”. The ADG brass that I have is measuring .3370”. My question is… is that an acceptable range or would it be better if the brass was wider or smaller? What is ideal?

Can you pm me your number?