sticknstringer22

Was a bit nervous painting a 1500 dollar gun but i think it turned out well. We will see if it functions and increases my predator...

Yep will do!!

I can't get any ammo to feed in gun now. Only shooting a break, no suppressor. Gun is boxed up and getting shipped to Christensen...

The bolt will not close and the shell will not feed all the way up. Needs another quarter inch to flush up and allow bolt to close. It's...

Hornady eld x loads, i have cleaned it with bore rope and barnes carbon cleaner, then dry swabbed it about every 10 shots as I broke in...

Been shooting this 90 rounds. Bolt stuck around first box, got it with some force. Then 80 loads later 3 of the last shells stuck bad...

Found a good one to go off of. The 300 wby did not like the hornady bullets and powder. Gonna try some different combinations but the 7...

I have no advice on the load you posted, but my first advice would be to acquire more than one reloading manual. I would recommend Lee...

Ya it fed fine, I'll finish shooting this batch and watch for signs.

First reloads on the brass, just checked a hand loads and it went in decent and ejected fine also. The pics above are from the bullet.

I see some lines but could that be from a burr?

Like I said it feeds difficult. Push it forward then back n in sometimes or just feed it kinda hard and it goes first time. Could this...

Yes this is a Ridgeline, i will check the bolt for lube, also looking at bumping the neck.

When we say jammed, most of us mean the bullet is touching the land. If you followed the book, you would likely not be touching the...

I will look into bumping the shoulder back thanks