Rooterpig

Write up on opening day Wyoming! Yes a handgun was used...

I enjoyed post/pics. Thanks Chris.

Well apparently we done something rite. She appears to work perfectly.

Just my two cents worth, but several of the previous replies mention "HARD CAST" bullets (SOLIDS!!) and I TOTALLY agree. While carrying...

Measure a fired case and see how much you are resizing . To much and you will separate the case .

After reading multiple pages by Mike Bellm and re-reading the other post here, I started to work. I wanted to do the easiest part first...

You could also color your bullet with a sharpie. If it is touching the rifling,it will rub off the sharpie. Seat deeper until you don't...

I just tried this method with the foil. I measured the foil at .0011 before the test. Inserting the foil and closing the action, the...

I would not have the bullet touching the lands. I would measure headspace with a feeler gauge and then make sure my case was not...

4 targets, 5 shooting positions 100 yards left hand shooter. The bull is the size of a quarter. First picture off bipod with rear...

I would pull a bullet out of the Hornady round and insert the case back into the chamber and measure case head protrusion. Compare that...

It was soft glass bead blasted. I just spin polished it after fitting a brake.

Below is a picture of my Kauger Arms (action & Stock) 6GT Black Widow put together by Omega Precision/Peter Angelos. 15.9" Bartlein 7.5T...

Did the lower end of barrel come glass beaded or did you do it ? Good looking setup.

Same here. But I read about this guy shooting pistol and it’s very interesting. I will try to find and post it.