Mickp7's latest activity

After having some issues with my 28 Nosler, my gunsmith confirmed the barrel is shot. I have other 7mm rifles and am considering a 30...

👍🏼 Got this after I started yesterday but I was close. Started at 65 of H1000, 2777 fps, 66 was 2809, 67 was 2854, 68 was 2910, 68.5 was...

LR Mag primers for the charge weights the 7PRC will run. I started at 66.0gr H1000, up to 70.0gr. 180 Hyb would be my personal choice.

I literally just finished prepping 100 rounds of new ADG brass for a 7PRC I picked up from Short Action Customs yesterday. Planning to...

I was taught that neck turning made all the difference from a person that had the national record for the 30 cal for a short period of...

How do you like this machine? I am very interested in the most consistent and accurate ammunition development possible. Neck turning...

My thinking: Annealing will reduce brass springback, providing additional neck tension & that will increase initial pressures, (steeper...

I have observed this also. Like upon turning necks two or more times, more brass is removed near shoulder than towards front. The little...

In higher pressure rounds with big case volume you end up with a certain amount of brass flow. I bought the RCBS machine to do inside...

Thanks MM. The speed up on that 300WM is right in line with what I am seeing. Fortunately, I was loading this bunch as I shot to...

Brass gives higher velocities until fully expanded to chamber dimensions then settles if minimal sizing is done. One of my 300WM’s goes...

Yes, sorry for the typo! 710 ES would be a whole other can of worms! 😂

Thanks Trm82! Just to make sure I don’t mislead, the 2940 fps was brass fired for the 2nd time, not annealed. The 3000 fps was was...

Finally got my AMP annealer and prepped my first batch of 300 PRC. Lapua brass was twice fired and annealed for the first time before...

Try Short Action Customs. They are working on a build for me and mentioned a few weeks ago they had some. I recommend calling them as...