Recent content by LONGRANGE JUNKIE

Pat Thank you. So i did what you asked. Removed the bolt group inserted a Petersen factory round and it went in smooth and dropped out freely. I inserted my load and it seemed to go in freely however wouldn't drop out without a rod to touch it out. I used a mic and and measured the two pieces...

Venatic That is what I'm seeing right at the end of the brass. It measured .001 lager than the factory loads I have.

Pat Thank you. So i did what you asked. Removed the bolt group inserted a Petersen factory round and it went in smooth and dropped out freely. I inserted my load and it seemed to go in freely however wouldn't drop out without a rod to touch it out. I used a mic and and measured the two pieces...

250 rounds now. Speed never changed. Same powder. Full length sizing. I will try the alcohol

Thanks DSheetz I will try that today.

I am running the JP silent capture. I am not running suppressed right now. Checked the gas tube and does not seem to be plugged. So I'm confused. I am down to the recommended starting load and I'm hearing that I'm running to hot? I also am not ejecting all the time. I will catch a half ejected...

I have a 22 Creedmoor ar-10 with a 22" barrel 1-8. I am having trouble with pushing primers out. Brass is Hornady 6.5 Creedmoor. I was loading 40gr of h4350 and was having good results using Berger 80.5 full bore. pushed them up to 41 grains and lost a primmer so I backed back off to 40gr...

Thank you guys

I have been told that H4350 work great, however in my area I haven't seen it for over a year. I am looking for help using either Varget or Superformance powder. These are a couple I have now.

22" 1-8 twist

I have a new 22 CM in a AR platform and with limited powder and limited load data available I am trying to come up with a starting point using components I have in stock. I am looking at using 6.5 brass, CCI 200 primers, Varget or Superformance powder and Hornady ELD-m or BTHP. Does anyone have...