Josh06

Savage small shank 260 remington x-caliber carbon fiber prefit. 1-8 twist, 22", threaded 5/8-24. I have RCBS dies and a lee neck...

Thank you for your reply! Those rails are actually the ones that I am looking at getting for my Savage, LOL!! Glad to hear someone else...

Very nice to know that, Josh. I have often wondered about fire forming NI plated Win 280 Rem to AI. I would keep a special watch on...

I found a good deal on 50 primed Speer nickel coated 30-06 cases on gun broker several years ago and picked them up to use in my...

I prefer to have a 20 moa, not that it's needed but I like to have my scope on the lower end of the total travel and it will usually...

I went 25cm to 22cm with no issues.

1 long action standard bolt face - 280ai 1 short action mag bolt face - your favorite 30 cal short mag, WSM, SAUM, Sherman, etc..... 1...

Nice! I've been seeing them regularly in the morning between 8 and 9 at my feeders.

I use a dead air e-brake on my diligent defense enticer S and don't notice any difference in sound but it does reduce recoil a little.

It's right around 1-1.5 inches at 100 consistently.

I'm shooting those with 26gr CFE 223, cci 450 primer out of a bolt action 20" 8 twist 223. 1.905 is my BTO, COL is about 2.180...

I don’t see that anyone has started one yet, so here goes (if one already exists, I’ll pull this down). My Daughter is on the board in...

Thanks all for all your input. I have a Grayboe Phoenix 2 with bottom metal to accept ACIS mag on order. Expect an 8 week or less delivery.

No I had to inlet for that also. Had to take a lot out around the front action screw, basically level that area to the same depth as...

I had to remove a little more than I was anticipating but still not too much. Here is a pure precision altitude opened up for a top...