joelpend

41.3-41.5 has worked in 3 different barrels for me. If there is a better powder for 6CM than H4350 I have not discovered it.

It is a very thin case so neck size is probably all you need. There are some 32-20 with a 308 bore. Sounds like your sizer would work...

IMO the Forster is very good and I have found it quite accurate regarding consistent lengths. They also make 3 in 1 trimmer heads that...

This scope is as new. Was mounted on a rifle that went to the range a couple times to shoot from the bench. Sold the rifle so now the...

Was it VV Powder? I have had and know of several experiences with VV going bad and it gases off with super corrosive acidic gases...

I have a aftermarket spring in Tikka T3 used for target work and no issues with hundreds of rounds. I have 2 bolts and 3 barrels for...

Lightweight magnum hunting rifles are not what you want for PRS. Also the Savage action is not desired for PRS. I own Savages so not a...

Snipped from another forum. Having worked for Kaiser Aluminum for several years in an extruded bar facility, I can assure you this is...

From what I have read and understand, brass is not affected by rapid or slow “cool down”.

I would say not a primer issue. Light strikes are apparent on 2 of the 3 cases and the 3rd case you probably attempted to fire it twice...

Everytime.

Try ASSRA.com

Custom one of a kind rifle chambered in 338-404 35deg shoulder. Built for 1000YD BR so weighs 16lb 4oz with the Weaver scope as...

You shim the rear, bed the rear with JB weld and make the bedding thinner up front and thicker at the rear, or you can get Burris...

H1000 is pretty popular with the ELR guys shooting the big 338 like 33XC. Burn rate may look a little fast but it just plain works or...