jjh1's latest activity

That will be nice!! Now if we can just get quality primers!! In 25 years of reloading I've never had a box of bad primers.

Well, after all of this it turns out I had bad primers they were brand new, remington 9-1/2. Switched to some cci primers and worked up...

Good points. There is a dimple where the primer was hit which baffles me, you'd think they would have fired

I agree with waspocrew, neck them up to 308 first then run through the 6.8W sizing die.

I used 52 gr of IMR4350 with 150 gr bullet. It's the very low end of the load data. I had the same thought you did, so I loaded one at...

Thank you so much for all of the info. I will measure the shoulder and check that. The fact that it won't snap into the bolt face and...

I appreciate it! So here goes, I bought ADG 7SAUM brass. Sized it and trimmed it. Wouldnt catch in the bolt face so I left the bullets...

I'm trying the same thing, can't get most round to fire even after removing extractor pin and seating bullets long so they are shoved...

I'm pretty new here but have been reloading for a long time. I'm having a hell of a time trying to fire form 7 saum. Wonder if I could...

Sure worth a try at this point. Have $150 in the 7 saum brass that I hate to waste. Thank you!

So life being what it is I just got around to finally trying to shoot the gun. I remove the extractor pin and left the bullet's long so...

That worked, thanks!

Thanks for the heads up. When I emailed them before I started building this gun they said they had no plans of producing it so that is...

Wow, so they got shorter after pushing the shoulder out....... Shoulder expanded and it pulled the neck back?

From what I'm seeing 7 saum starts out at 2.035 long and 6.8 western is to be trimmed at 2.020 so I'm curious how your brass is that...