Jack Sherwood

I have a Savage 111 synthetic and although a little 'crisp', not unpleasant or unmanageable. It's comparable to the 30-06 with heavy...

Call Barnes and they will give you load data for the 250gr TTSX. They also said that you can use the same data as the 250 TSX for the...

I'm using IMR 4350 for Barnes 250gr TTSX. Mine likes max loads, worked up from minimum and showing no pressure signs. Start low is my...

I shoot a 9.3x62 also. Simply devastating on elk using 250gr Barnes TTSX hand loads.

Not quartering is a a recipe for disaster even in sub zero temps with elk. I’m a little surprised the other hind is ok honestly. They...

For my 300wsm Remington, I’m at 2995 fps with 63.9 of h4350 with a Barnes 180 tsx, federal 215 mag primer, and Barnes brass. 24 inch...

Good Morning, I am just curious about the reach for extra velocity out of a short barrel rifle with the case already at max capacity...

Lucky in that he was able to get the semi-auto "back in the fight"! A jammed or "out of battery" is one of several reasons that I'm...

Is it a necessity? No! But it probably won't hurt use a Lee Factory crimp die. They don't hurt your accuracy, and in some cases actually...

This is not based on experience just physics. A 30-30 is a 308 Win is a 30-06 is 300 Win Mag it is simple a matter of distance. X...

I'd run the 143 LH if forced to choose. Id also more likely trade that rifle for a .375 Winchester. Just me.

For any cartridge I'd go all copper. If going with the .30-30, choose a bullet and note minimum impact velocity for full expansion...