Recent content by EndersPrint

  1. E

    Vortex lht comments?

    Agreed. Like all Vortex products the MSRP is a bit scammy but if you shop around you can find good deals. I picked mine up on BH Photo a few weeks ago for $1100 with a free gift (olight flashlight/laser pointer). Saw it on Dvor a few days ago for $1150 iirc. Can't beat Vortex's warranty either.
  2. E

    Vortex lht comments?

    I just put a FFP LHT on my 300wm hunting rifle; I can't comment on the durability but the clarity and weight are very nice. It's replacing a gen2 Razor 4.5-27 that served me well but I'm tired of carrying it around in the backcountry and I suspect the 2 pound reduction is going to help with...
  3. E

    Hornady Threaded OAL/CBTO Case

    I've used a collet bullet puller to cycle a bullet through the neck several times to reduce neck tension. Other suggestions are probably better but maybe this matches your tools on hand.
  4. E

    Hornady One Shot Inconsistency

    I give a very light spray on the brass in a loading block from all four sides, brass upright, and see about +/- .0015" shoulder bump variance with a Forster bushing bump neck sizing die with no expander FWIW.
  5. E

    Rem 700 Primary Extraction RR serial #

    I don't have much more to add, but I personally would start measuring your prepped brass and comparing it to factory ammo/brand new brass. I'd also confirm it chambers with zero resistance with your ejector and firing pin removed. Good luck, I'm curious what you figure out.
  6. E

    Rem 700 Primary Extraction RR serial #

    Before I realized I had a bolt timing issue I was inspecting chamber/brass for signs of burrs or other damage. I even polished the chamber with Fitz hoping to remedy my issue. Any streaks on extracted brass? I found that some factory ammo extracted fine while others required a mallet. Is the...
  7. E

    Hello from Reno, NV

    Thanks Heavyiron, glad to be here!
  8. E

    ISO 143 ELDX HORNDY BULLETS

    Midway has some seconds available, my batch seemed pretty good. Looks like they raised the price to full retail though https://www.midwayusa.com/product/102052528
  9. E

    Good gauge for measuring case neck

    I just picked up a Mitutoyo 115-313 at a reasonable price on eBay to start my neck turning adventures. So far so good.
  10. E

    Wet Tumbler

    I SS wet tumble with 1/4 tsp of lemishine and 2 tbsp dawn, rinse and separate pins with Frankford wet/dry media separator and dry with a lyman case dryer. Very satisfied with results and ease of process.
  11. E

    Scale

    Another satisfied V3/FX120i user here fwiw
  12. E

    Hello from Reno, NV

    Thanks!
  13. E

    Hello from Reno, NV

    Thank you kindly! Eastern Washington is high on my to visit list, looks beautiful.
  14. E

    Hello from Reno, NV

    Thanks!
  15. E

    Hello from Reno, NV

    Thanks guys! In preparation for my first deer tag I've been practicing with rifles and doing load development. I enjoy long range plinking at our local range. Last fall I went on my first bird hunts so I'm learning shotguns too; I'm a novice there also. I'm practicing pistols and carbines a...
See more

Top