Recent content by Dilly_9

I think I’m going to get the barrel threaded, upgraded bottom metal, new mags, trigger spring and the longer bolt stop. Maybe a stock pack or check riser and give that a run first. Thank you all for you input!

Which stock did you go with? Also, does your stock take the factory bottom metal?

Much appreciated! Do you know if the EH1 has a stock inlet for the tikka bottom metal? I’d call but I’m sure they are closed on weekends. Nice to have the flexibility to widen the channel potentially down the line to support a proof or carbon six barrel if the build gets that far.

Yessir!

Thanks fellas. All good points! I’ve shot it quite a bit (260) round count) and it shoots right at 1 MOA. My scope is the Vortex LH 3x15 and rings are lapped. The stock just has that plastic flimsy feel to it. Trigger spring is definitely on the list. Tossed around the idea of getting a 300 PRC...

Looking for more capability, accuracy while saving weight. That being said, any insight on stock, barrel options would be appreciated. Tikka’s are known for not allowing longer, high BC bullets without swapping the bullet stop but I’m sure I need to change out the stock/mag set up etc. I like...

Been reading through all the comments for suggestions on modifying my Tikka 300 wsm. I’d like to have the ability to load longer bullets and looking for suggestions on build options. Not sure if this appropriate to stem off of this discussion but if possible (and appropriate) can you through out...