Recent content by cobra

I have a Springfield M1A with a stainless barrel and composite stock. I haven't done any accuarizing with it and it will hold 1 MOA off the bench very consistently. I have on it smith enterprises bases and rings and a Leupold 3.5/10 M3. I have shot it with iron sights in service rifle...

I have a 30-378 in the stainless synthetic and the stock is definatly the weak point of the rifle. Haven't ever had an accumark but the stock looks to be a much more solid piece than the stainless synthetic. Why not a sendero in 300 RUM? Much better cost to performance ratio.

I ordered the Exball program from perry systems and i am very impressed with it. You can order it at www.Perry-Systems.com. I really like the mil radian come up feature. And the program has bcs for all the popular bullet manufactures.

I have a set of the Smith Enterprises rings. I have been fairly impressed with them. They are very low. I had them on a Leupold 3.5-10 LR with 40mm objective and clearance was close on the barrel of a sendero. They do come with 1" inserts but I have never used them. Also if anyone is looking for...

I've shot 168 A-Max out of a Rem Sendro in 300 win and they have performed very well. In fact I shot my best group with them. I haven't shot them at anything live over 400 yds but the 275# wild pig at 375 yds fell dead in its tracks on a shot that impacted in between its shoulder blades. In my...

I've got a forster case trimmer and I can't fit a 30-378 case in it. I contacted redding reloading and they said it wouldn't fit in theirs either. Anyone have a trimmer they like that will fit something big like that?

No I really haven't had the time to go out and shoot but I do have a new set of 200 grn. Match Kings to try out with WC872. I hope they do better then the Barnes XFB's. I am in the final few steps of a medical seperation from the Marine Corps and soon I'll have a little more time to work with...

I recently bought a Wby MK 5 stainless in 30-378. After lots of accuracy testing with bullets 168-220 grns it wasn't inmpressing me. My question is of what quality is the action and should I use it for a cutom gun in say 30-338 Lapua or even 30-378. I have done a lot of shooting but never...

I've seen a lot about these range finders just not where to buy them. I can't seem to find any links off their website so does anyone have any recomendations on a good seller?

I am starting to develop loads for a 30-378 and I'm familar with the barrel errosion problems. I just wanted to know if a ball powder like H870 would be better about that then a grain powder like H50BMG? I believe I read something brief about that on this site but I can't seem to find it agian...