Blancoalex's latest activity

Good question I have a factory 700 in 30-06 and I have had a few I really thank my next one will be a model 70 or savage 110.i know when...

that is because you are trying to go straight to 6mm. you need to use intermediate steps. use a 308 die to set the body shoulder close...

Isn't most case forming for the 6 HLS done with either necking up .22-250 or necking down .250 Savage cases? I have never seen one, but...

I use a cutoff wheel on my Dremel tool to remove the bulk of neck length then finish with case trimmer saves a ton of time. just made...

I am waiting for RCBS 6mm trim die to show up. Assume I will need to shorten it also.

just remove the decapping stem and let brass run right up through the die and cut to length at the end

I do have 308 Win,7-08, 260, and 243 dies to try adding into steps. Thanks for suggestions

NO did not anneal , most of what I have read says anneal after forming. Thinking about trying a 243 Win case also.

OR, good time to buy used equip from folks giving up from lack of components.😱 Reloading is like owning a bass boat to win tournaments😂...

As stated in a couple of places above, reloading has many facets to it. I reload pistol cartridges and AR loads for convenience and...

I don’t look at it for the dollar savings, but knowing I have consistent ammo that will shoot the best out of my rifle.

Looking for advice and help forming 6mm HLS cases using standard 6mm Remington cases. I have cut back an extra 6mm Rem sizing die to...

Look up also AR barrel extension , the 760 uses similar setup.

Look up Accuracy Systems in Byers,Co.

Ttt