222 Fireball

This, plus Tiny Tim's post, reflects my experience with a brand new Weatherby in .308, where some batches of factory ammo were so hard...

Re-read your original post. Are you saying you never checked a resized case in your chamber? If so, your sizing likely lengthened your...

Now replace the OP typo "that" with "than" and now it reads with more sense. Makes for a little less of a bread sandwich now.

Mega stink, are you there? Wake up! It’s ok you passed out from info overload! Take a few breaths and focus

Along with this, after you chamber a loaded round, remove it from the chamber and look for rifling engraving marks on the bullet...

The OP said: The bolt requires ever-so-slightly more pressure to close that with an empty fired case. More often it's the other way...

Just measure the case length to be sure you’re getting tension from the shoulder and not the case mouth going into the start of the...

Take your first fired round and slide it over the bullet of an unfired round. I've run into chambers that have a tight neck. Just make...

If you’re in the need to buy brass don’t overlook small rifle brass and small rifle primers which are more readily available and...

First of all, I use magnum primers in all of my rifle loads. I have found the Federal GM210M, Large Rifle Magnum primers to be reliable...

Welcome to the site. When it comes to primers, get what you can find in large rifle. There is no need for large rifle magnum primers for...

Fantastic. Congratulations on your epic milestone.

The rifle holder is a nice feature , But I like that sako and Leopold a lot better 😁

I have been using the Kifaru universal gun bearer for a few years now and am very pleased with it.

Looks like they changed the design some. https://exomtngear.com/collections/k4-accessories/products/k4-rifle-carrier