Painting rifle

chain

Well-Known Member
Joined
Dec 28, 2004
Messages
367
I have been working on a Savage stock and I am ready to paint it. Before I do I have seen these rifles that are totally painted not just the stock. Is that some special bake on paint or can you use regular spray paint? I bought the stone type/ fleck paint but I don't know if that will adhere to the barrel and action? Thanks
 
Chain,

Also if you're into changing colors of the rifle every so often you might try ordinary old craft paint of the outdoor variety.

I airbushed my whole 222 Rem in a REM 722 a couple of years ago and she's holding up well. Including metal and wood.

Another product used for stocks is the spray on truck bed liner. Leaves a tough finish with just enough roughness. This would be just for the stock.

Yet another method is to do the full body shop thing to he wood as with an auto body. Every thing is 800 grit smooth and filled. Then base coat w/a pearled paint and then candy it for effect then clear coat. This is my favorite finish by far. Holds up very well and I like smooth rather than rough anyway.
 
I have only used Dura Coat but here is what i have found so far with it.

If you order the starter kit from Dura Coat they will send you a cheap air brush with a connection to a canned air bottle, if you are serious about wanting to do it i would recomend you buy a decent airbrush with small compressor, it will work alot better. As for degreasing the parts i have had good luck with Hoppes Gun Scrubber, it has a powerful blast and works well. When painting the metal parts make sure they have some texture to them. ANy kind of matte finishing will work well. As for the bolt on most of the rifles i have done the bolt sleeve is usually very smooth, i would imagine emory cloth or some kind of fine made for metal sanding paper would work good. Also make sure you degrese the bolt very well, some of the internal grease can cause paint not to stick. I have never disasembled a bolt for painting but i would bet that would work as long as you watch what parts you paint. As for brakes i have painted a few and with the simple spray on dura coat i have not been able to get the paint to hold on to the parts of the brake that the high pressure gasses hit, but this has only been in large colume rounds. If you are wanting to do some kind of custom pattern i have had the best luck with simple masking tape, some other stuff has pulled paint off of under layers.

And on a last note, wear a mask and find somewhere with some good ventaltion, that stuff can get you goin in a bad way!!! Also do several layers on any parts that will recieve the most wear.

good luck
steve
 
Thanks I was going to do just the stock and then I thought I might just do the whole thing. I have bondo'ed a cheek piece and extended the LOP on a savage plastic stock. It is flat black primer now. Thanks again
 
Warning! This thread is more than 17 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top