G
Guest
Guest
What would be the best way to set up my Redding Type S f/L bushing die. I have read a few things about setting the shoulder back 1 thou for bolt actions. OK easy enough, but after measuring my brass with a stoney point headspace guage I show the sizes to be different Headspace wise. Some of the brass is 1-1.5 thou different than each other. Is this because the cases are not yet formed to the chamber?
Sinclair says to neck size only until after the 2 or 3rd firing. Is that the case?
I guess I should just keep firing new brass till I get a good amount of fired stuff...then worry about it?
Any help would be great
Joe
Sinclair says to neck size only until after the 2 or 3rd firing. Is that the case?
I guess I should just keep firing new brass till I get a good amount of fired stuff...then worry about it?
Any help would be great
Joe