shootallday
Well-Known Member
Normally I always fireform new brass, either the traditional way or the cow method. But I am very low on primers, there not even the primers I'd prefer but there what I've got. Not much powder either, maybe a half pound of H-1000.
So I've got new 6.5 prc brass to try out thanks to b-lot banga. This brass weighs about the same as the hornady and volume looks close to. I know there's a good node at about 57-58 grains, I've seen it and many others loads seem so as well.
So should I just work a load up on new brass and not rireform. Will be for deer hunting under 500 yards.
So I've got new 6.5 prc brass to try out thanks to b-lot banga. This brass weighs about the same as the hornady and volume looks close to. I know there's a good node at about 57-58 grains, I've seen it and many others loads seem so as well.
So should I just work a load up on new brass and not rireform. Will be for deer hunting under 500 yards.