Feeding Problems

tweek1142

Well-Known Member
Joined
Nov 8, 2012
Messages
171
I have been reloading for eight years now and have not ran into a problem like this before. I have a 300WSM and when i resize the brass i do so by bumping the shoulder back .002. I just tried to load up a shell and the shell was too wide to push down into the magazine. its too wide to get past the race ways.I have a hinged floor plate magazine. What could cause this?

Thanks
 
Warning! This thread is more than 12 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top