Time Killer
Well-Known Member
- Joined
- Jan 26, 2011
- Messages
- 160
Ok guys, spent my morning measuring and re measuring.
I have annealed some cases, reset die, went through the whole process again.
Same result.
So, my question now is about the expander ball.
What should the difference be between ball and bullet? Or even ball and case mouth.
It appears that my bullets are same size as the expander ball. Makes sense that they slip hu?
I have annealed some cases, reset die, went through the whole process again.
Same result.
So, my question now is about the expander ball.
What should the difference be between ball and bullet? Or even ball and case mouth.
It appears that my bullets are same size as the expander ball. Makes sense that they slip hu?