longgunshooter
Well-Known Member
Curioys as to what is everybodys favorite puller? I have the rcbs intertia puller that i have been using for years...
Same hereFor ease, simplicity and speed the Grip-n-Pull is hard to beat.
I have never seen one of these. Had to google it. Does it damage the bullet or make a mess? I never liked the inertia puller. Kind of a PITA. I have some factory ammo to unload. Will it work pulling bullets with a crimp?For ease, simplicity and speed the Grip-n-Pull is hard to beat.
The trigger is also my favorite puller. Except I have 2 boxes of factory ammo that is hard to close the bolt on and the 5 rounds I was able to close the bolt on were very hard to lift the bolt on after I shot them. Kind of makes me nervous and it is expensive factory ammo. Only have 1 gun this has ever happened on.My favorite bullet puller is the trigger.
If that doesn't work, Hornady Cam Lok.
Forster collet is right there with it.
The Forster fits best in the Co-Ax, but with adjustment, the Cam-Lok will fit too.
Sounds like a PITA.The trigger is also my favorite puller. Except I have 2 boxes of factory ammo that is hard to close the bolt on and the 5 rounds I was able to close the bolt on were very hard to lift the bolt on after I shot them. Kind of makes me nervous and it is expensive factory ammo. Only have 1 gun this has ever happened on.
This is a christensen 28 nosler rifle and nosler factory ammo. I still haven't figured out why it won't chamber. I'm guessing the case is a little too long. One box is 175 ABLR the other is 160 AB. Had 1 box of 160 AB that went through fine. After I FL size and trim them all is good.Sounds like a PITA.
Brother's Tikka has a very short throat/leader where neck & OAL case length at the high end of SAAMI spec won't fit. Ironically, discovered this with Lapua factory ammo.