Thanks to you all for your inputs and I may very well send you a PM for that load Doug when I get around to it.
Loader loft, I am using the one shot but I am sure its the correct I have always used. I usually read the can to refresh my memory as I always feel I over spray trying to get it all. I have had a couple cases stuck in dies.
The damage I explained, I found after shooting the round and none others did it? It never slowed me down and never happened again. Maybe it was from not wiping off the case after loading. Anymore inputs on that always welcome. Thanks
I am about to load this brass for the 3rd time and watch it and see how it goes.
Anyone annulled any of this brass and when should I? I see no problem right now, am I missing something?
Still trying to get up with Que on the muzzle break not that I want to use it but whoever ends up with this gun someday after I am gone might want to screw it back on since its paid for. Its to much stress for me personally not only trying to find the perfect light and heavy load but then trying to tune that particular round in with the que and all before I ware the barrel out. I am just gona set this up for long range heavy shots and when I don't think I cant get it with whatever I have in my hand, the 7rem mag or 06, then I will grin and pull it out of my hat somehow! Last two big bucks I seen over the years were well out there and I wasn't ready. I missed with it and said to myself, you suck! I would have been better off with my other guns aiming hi. I hope to master this thing shortly. Thanks for your inputs
I will always be watching this site if you guys learn anything I should know, I appreciate your knowledge and experience.
I decided the place I am feeling inside the cut away brass is where it gets thicker towards the web about 1/2 inch before the web coming from the mouth of the case. So with that I have decided to safely reload, but I am listening.
Thanks to all
Carl