As you can see by my post number I really do not get much time to post. But what happened at the range was impressive that I feel that I should share my experiance. I purchased my 40X new in 1989 it came complete with a test target that measured .74. Not very good in my opinion. Over the years I tried many differnt loads and eventually got this down to between a half inch and three quarters inch. As this is my only long range gun accuracy started to fail and I new it was time for a change in the pipe.
Here is what I did ordered a new pipe from a top company after reading this forum installed a big lug, Sako extractor and rebedded to fit the new barrell. Had time to go to the range yesterday and start break in process, after loading up some mild loads. I shot 3 times and made scope adjustments to get colse.
In either case I shot 5 shots cleaning after every round and shot a group tha measured outside diameter on my calipers 5.07. I am shooting a 7MM Remington Mag which is .284. I believe if I am correct that this is less than a quarter inch group. I have pictures on my phone but do not know how to get it on here from my PC.
40X re-build.
Broughton 1 In 9 Twist
Off Brand Lug 1/4 inch thick I think it waqs a PPG Lug.
Bolt and action blue printed. Did not need much.
Re-Bedded
Sako Extracter installed.
Defensive Edge Muzzle Break 3 port.
Break in Load
Nossler Brass
168 Sierra Match
H1000 70.0 Grs
Here is what I did ordered a new pipe from a top company after reading this forum installed a big lug, Sako extractor and rebedded to fit the new barrell. Had time to go to the range yesterday and start break in process, after loading up some mild loads. I shot 3 times and made scope adjustments to get colse.
In either case I shot 5 shots cleaning after every round and shot a group tha measured outside diameter on my calipers 5.07. I am shooting a 7MM Remington Mag which is .284. I believe if I am correct that this is less than a quarter inch group. I have pictures on my phone but do not know how to get it on here from my PC.
40X re-build.
Broughton 1 In 9 Twist
Off Brand Lug 1/4 inch thick I think it waqs a PPG Lug.
Bolt and action blue printed. Did not need much.
Re-Bedded
Sako Extracter installed.
Defensive Edge Muzzle Break 3 port.
Break in Load
Nossler Brass
168 Sierra Match
H1000 70.0 Grs