284stak
Well-Known Member
I have a 700 Rem moly action with the bolt face opened for a 330 Dakota w/Sako extractor. The dakota bolt face is larger than the ultramag, but smaller than the lapua.
Would like to switch to the 338 edge or lapua and am leaning towards the lapua since I have the HS DM system which can accom the COL of the lapua.
Does anyone see any reason not to switch to the lapua vs the edge, given the above? Brass cost is not an issue and I have a PTG reamer for an improved lapua.
Does the 338 LM PTG 700 bolt offer any benefit over the factory rem 700 bolt fitted w/sako extractor and trued?
Thanks
Would like to switch to the 338 edge or lapua and am leaning towards the lapua since I have the HS DM system which can accom the COL of the lapua.
Does anyone see any reason not to switch to the lapua vs the edge, given the above? Brass cost is not an issue and I have a PTG reamer for an improved lapua.
Does the 338 LM PTG 700 bolt offer any benefit over the factory rem 700 bolt fitted w/sako extractor and trued?
Thanks