Fiftydriver
Official LRH Sponsor
Robbor,
Yep, as mentioned, look at the pic that SS7mm posted comparing the 2" BAT with the Rem 700. You can see the recoil lug under the receiver. I also bedded my receiver so that the rear of the receiver is also acting as a recoil lug eith a tapes width of clearance on the tang taper to prevent any wedging effect that may cause a split. The rear of this receiver has more bring surface then the recoil lug!!!
I believe my barreled receiver is a bit over 30 lbs. add a 25 lb stock, a very heavy USS Xotic scope and 1.5 lbs worth of scope rings and you are pushing 60 lbs in a hard way!!
Dan lists my barrel at $510+shipping. The price goes up quite a bit for a 2" diameter barrel at 40" with a price of $570. Yes it will cost $30 to ship one of these barrels so D-As price quote is right on the money!!
Yes, if you go with a 2" BAT, it really does not make alot of sense to go to less then a 1.750" diameter barrel. Even if your only going to use 30" of barrel length, the receiver will take it easily and the **** thing is already heavy so why not make it as stiff as possible.
Bruce also makes a 1.650" x 10" and a 1.750" x 10" receiver as well. For the lighter barrels in the 1.500" range these are good choices.
For a 1.350" to 1.450" barrel diameter I like his 1.55" diameter receivers. With a real long 1.5" barrel I would recommend a barrel bedding V-Block. May not be needed but still would recommend it just to be safe.
Good Shooting!!
Kirby Allen(50)
Yep, as mentioned, look at the pic that SS7mm posted comparing the 2" BAT with the Rem 700. You can see the recoil lug under the receiver. I also bedded my receiver so that the rear of the receiver is also acting as a recoil lug eith a tapes width of clearance on the tang taper to prevent any wedging effect that may cause a split. The rear of this receiver has more bring surface then the recoil lug!!!
I believe my barreled receiver is a bit over 30 lbs. add a 25 lb stock, a very heavy USS Xotic scope and 1.5 lbs worth of scope rings and you are pushing 60 lbs in a hard way!!
Dan lists my barrel at $510+shipping. The price goes up quite a bit for a 2" diameter barrel at 40" with a price of $570. Yes it will cost $30 to ship one of these barrels so D-As price quote is right on the money!!
Yes, if you go with a 2" BAT, it really does not make alot of sense to go to less then a 1.750" diameter barrel. Even if your only going to use 30" of barrel length, the receiver will take it easily and the **** thing is already heavy so why not make it as stiff as possible.
Bruce also makes a 1.650" x 10" and a 1.750" x 10" receiver as well. For the lighter barrels in the 1.500" range these are good choices.
For a 1.350" to 1.450" barrel diameter I like his 1.55" diameter receivers. With a real long 1.5" barrel I would recommend a barrel bedding V-Block. May not be needed but still would recommend it just to be safe.
Good Shooting!!
Kirby Allen(50)