What's the serial number prefix?Remington factory extractor. Worked fine for new brass
What's the serial number prefix?Remington factory extractor. Worked fine for new brass
Interesting. I was unaware and will check later. So your saying the serial number prefix will read RR? Possibly cam timing issue. Okay, thank YouIf it's a Remington RR prefix serial number than you could possibly have a Primary extraction issue. Has nothing to do with the extractor, it's all bout the timing and cam over of the bolt cycle. Won't show on new brass and only shows on fired brass. I've had the issue in 2 of my Remingtons and both were RR prefix serial#s. Can also happen on older actions when you have them Blueprinted.
Correct. RR serial numbered actions are notoriously known for PE issues. It can also show up when an action has been blueprinted as it can slightly change the PE timing.Interesting. I was unaware and will check later. So your saying the serial number prefix will read RR? Possibly cam timing issue. Okay, thank You
That sounds like what I have going on too.Correct. RR serial numbered actions are notoriously known for PE issues. It can also show up when an action has been blueprinted as it can slightly change the PE timing.
Here's a chat about it.
Rem 700 extraction Issue
Wondering if anyone has had any extraction problems with a Rem 700 action? I have a 30-06 shooting Lapua brass with a stout load. Rounds chamber fine both. Bolt lifts up just fine after firing (bolt lift feels same if I fire the round or don't fire the round). BUT, when I try to pull the bolt...rokslide.com
Thank YouI had mine fixed by Long Rifles Inc. aka LRI. Some Smiths can do it and some can't. LRI is well versed in fixing it if that's your issue.
Same here…also APR in TexasI had mine fixed by Long Rifles Inc. aka LRI. Some Smiths can do it and some can't. LRI is well versed in fixing it if that's your issue.
JAYgs8163: , I checked serial number and the prefix is RR and it's a PE issue . Very disappointing but fixableCorrect. RR serial numbered actions are notoriously known for PE issues. It can also show up when an action has been blueprinted as it can slightly change the PE timing.
Here's a chat about it.
Rem 700 extraction Issue
Wondering if anyone has had any extraction problems with a Rem 700 action? I have a 30-06 shooting Lapua brass with a stout load. Rounds chamber fine both. Bolt lifts up just fine after firing (bolt lift feels same if I fire the round or don't fire the round). BUT, when I try to pull the bolt...rokslide.com
At least you know what it is and can address it properly now! Good luck!JAYgs8163: , I checked serial number and the prefix is RR and it's a PE issue . Very disappointing but fixable