Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Why not?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="lazylabs" data-source="post: 144062" data-attributes="member: 6641"><p><strong>Re: machining nightmares</strong></p><p></p><p>I think you would have to show in the end that a one piece setup would be straighter with regards to the action/barrel than a tradition two piece setup. I think you have to find a different kind of interface between the bolt and the action to eliminate the alignment problems we see now. There would be problems lapping anything without cutting the ends off afterword. The lapping produces a bell shaped hole on each end. The chambering could be done with a plunge style EDM with an electrode long enough to reach through the action section. I know there are people cutting chambers with edm's now. I just don't know if you would be emilinating one of the causes off lost accuracy. It would be nice to see more actions with integrated bases at least. Have a good one.</p></blockquote><p></p>
[QUOTE="lazylabs, post: 144062, member: 6641"] [b]Re: machining nightmares[/b] I think you would have to show in the end that a one piece setup would be straighter with regards to the action/barrel than a tradition two piece setup. I think you have to find a different kind of interface between the bolt and the action to eliminate the alignment problems we see now. There would be problems lapping anything without cutting the ends off afterword. The lapping produces a bell shaped hole on each end. The chambering could be done with a plunge style EDM with an electrode long enough to reach through the action section. I know there are people cutting chambers with edm's now. I just don't know if you would be emilinating one of the causes off lost accuracy. It would be nice to see more actions with integrated bases at least. Have a good one. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Why not?
Top