Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Who makes the best BARREL and ACTION VISES???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="J E Custom" data-source="post: 1035566" data-attributes="member: 2736"><p>WARNING !!!!!!!!!</p><p></p><p>Please don't weld on a barrel or action, nothing good will come of it.</p><p></p><p>The correct action wrench holds the recoil lug in place while tightening so no pins or any other means of locating the lug is necessary.</p><p></p><p>Also I have never found a factory recoil lug that was perfectly flat because they are not surface</p><p>ground like the better aftermarket lugs are. If you are going to the trouble to blue print an action and re barrel it, a $40.00 dollar replacement lug is a very good investment.</p><p></p><p>Again: Please don't weld on the action it will screw up the heat treatment in the worst possible </p><p>place The receiver ring and the recoil lug area. Also most barrels should not be welded on because of there Metallurgy and heat treat.</p><p></p><p>Just a word of advice</p><p></p><p>J E CUSTOM</p></blockquote><p></p>
[QUOTE="J E Custom, post: 1035566, member: 2736"] WARNING !!!!!!!!! Please don't weld on a barrel or action, nothing good will come of it. The correct action wrench holds the recoil lug in place while tightening so no pins or any other means of locating the lug is necessary. Also I have never found a factory recoil lug that was perfectly flat because they are not surface ground like the better aftermarket lugs are. If you are going to the trouble to blue print an action and re barrel it, a $40.00 dollar replacement lug is a very good investment. Again: Please don't weld on the action it will screw up the heat treatment in the worst possible place The receiver ring and the recoil lug area. Also most barrels should not be welded on because of there Metallurgy and heat treat. Just a word of advice J E CUSTOM [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Who makes the best BARREL and ACTION VISES???
Top