Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Whidden FL Bushing dies
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="QuietTexan" data-source="post: 2533827" data-attributes="member: 116181"><p>Trying to put a picture on what the last four guys have told you, their thoughts were mine as well.</p><p></p><p>Red circle is how the stem holding the bushing down is set to resize the most amount of the neck possible while leaving enough room for the bushing to rattle when shaken. The orange circle has the stem screwed out basically as far as possible to exaggerate the difference and show the range of adjustment on the bushing. I do vary the length of the neck resized sometimes, this particular 6.5CM die on the left is set up to resize for a rifle I run from a mag so I resize a lot of the neck relatively tightly. You can experiment with how much of the neck you do resize, partially sizing the neck is one way to further reduce interference fit below what a -.001" bushing offers.</p><p></p><p>Red circle has no decapping stem installed, the die works either way.</p><p></p><p>[ATTACH=full]367067[/ATTACH]</p></blockquote><p></p>
[QUOTE="QuietTexan, post: 2533827, member: 116181"] Trying to put a picture on what the last four guys have told you, their thoughts were mine as well. Red circle is how the stem holding the bushing down is set to resize the most amount of the neck possible while leaving enough room for the bushing to rattle when shaken. The orange circle has the stem screwed out basically as far as possible to exaggerate the difference and show the range of adjustment on the bushing. I do vary the length of the neck resized sometimes, this particular 6.5CM die on the left is set up to resize for a rifle I run from a mag so I resize a lot of the neck relatively tightly. You can experiment with how much of the neck you do resize, partially sizing the neck is one way to further reduce interference fit below what a -.001" bushing offers. Red circle has no decapping stem installed, the die works either way. [ATTACH type="full" width="441px" alt="IMG_0734.jpg"]367067[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Whidden FL Bushing dies
Top