Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Which Neck Sizer to use
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="elkaholic" data-source="post: 581828" data-attributes="member: 13833"><p>Thanks for all the input guys! What I have done is buy a full length 375 Ruger die to first push the shoulder back about .070", then use a 338 RCM die to neck down the first step. The third step would be either use my 30/375 S.I. die to create the 40 degree shoulder or maybe better yet, just fire form at this point since I have to blow the taper out a little anyway.I can use my bullet swaging press for any and all steps, so horsepower is not an issue......Rich</p></blockquote><p></p>
[QUOTE="elkaholic, post: 581828, member: 13833"] Thanks for all the input guys! What I have done is buy a full length 375 Ruger die to first push the shoulder back about .070", then use a 338 RCM die to neck down the first step. The third step would be either use my 30/375 S.I. die to create the 40 degree shoulder or maybe better yet, just fire form at this point since I have to blow the taper out a little anyway.I can use my bullet swaging press for any and all steps, so horsepower is not an issue......Rich [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Which Neck Sizer to use
Top