Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Which Brass for the 300 RUM
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Wachsmann" data-source="post: 1227567" data-attributes="member: 10429"><p>I pushed the Remington brass with full charge loads and I'll be the first to say in a RUM you better stop at 5 reloads FL sizing...because 6 shootings it comes apart...and you gun make a weird noise and the bolt is really hard to open to get the brass out....then you spend money getting it checked out to make sure there is no damage.....Any ways every thing can make a difference so go with what works best...I had heard the hornady brass was softer than Remington but I only have experience using the Remington. I havn't seen any 300 RUM Remington brass for sail since 2007. I've been using the 7mm RUM brass and neck sizing it up. I think after I run out I'm going to switch over to the nosler brass.</p></blockquote><p></p>
[QUOTE="Wachsmann, post: 1227567, member: 10429"] I pushed the Remington brass with full charge loads and I'll be the first to say in a RUM you better stop at 5 reloads FL sizing...because 6 shootings it comes apart...and you gun make a weird noise and the bolt is really hard to open to get the brass out....then you spend money getting it checked out to make sure there is no damage.....Any ways every thing can make a difference so go with what works best...I had heard the hornady brass was softer than Remington but I only have experience using the Remington. I havn't seen any 300 RUM Remington brass for sail since 2007. I've been using the 7mm RUM brass and neck sizing it up. I think after I run out I'm going to switch over to the nosler brass. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Which Brass for the 300 RUM
Top