Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
What tolerance for tight necked 6.5 x 284?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="308sako" data-source="post: 72840" data-attributes="member: 2766"><p>Another thing to consider is that the brass is springing back a bit after firing, so .290 0r .291 for the cut chamber is possible... therefore you have .001 per side already. I shoot a 6mm/284 with .0005 per side with no problems and no split necks. pay real close attention to loaded rounds neck diameter though! Centers the bullet and helps with accuracy.</p></blockquote><p></p>
[QUOTE="308sako, post: 72840, member: 2766"] Another thing to consider is that the brass is springing back a bit after firing, so .290 0r .291 for the cut chamber is possible... therefore you have .001 per side already. I shoot a 6mm/284 with .0005 per side with no problems and no split necks. pay real close attention to loaded rounds neck diameter though! Centers the bullet and helps with accuracy. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
What tolerance for tight necked 6.5 x 284?
Top