Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
What epoxy to use on recoil pad and HS stock
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Coyboy" data-source="post: 361765" data-attributes="member: 3733"><p>When doing the foam filled fiberglass stocks, I hollow out the stock about a half inch deep, and then fill with a 2 part epoxy and level off. After it cures I put it on the drum sander to get a perfectly flat surface. then the new pad can be screwed to the stock, scribed, taken off and rough ground. Then installed with the screws and a thin layer of epoxy, and finish sanded to fit flush.</p></blockquote><p></p>
[QUOTE="Coyboy, post: 361765, member: 3733"] When doing the foam filled fiberglass stocks, I hollow out the stock about a half inch deep, and then fill with a 2 part epoxy and level off. After it cures I put it on the drum sander to get a perfectly flat surface. then the new pad can be screwed to the stock, scribed, taken off and rough ground. Then installed with the screws and a thin layer of epoxy, and finish sanded to fit flush. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
What epoxy to use on recoil pad and HS stock
Top