Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
What could cause a jacket separation for a mid powered load?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jb1023" data-source="post: 1229790" data-attributes="member: 91995"><p>After I fired off the first few I was thinking they were oblong but when I walked up to check it was just the paper ripping. The paper was not flush with the backing due to the plywood backing splintering from previous trips (100M was plywood backing and 200M was cardboard). The actual holes in the plywood were all round. If I'm hitting 2" low at 100 I would figure about 1-2" below that at 200. I am going to clean my barrel with some wipeout, load up some more rounds and then try again starting at 100 and move my way back to 300yds. Might even be able to get out there this weekend, I hope.</p></blockquote><p></p>
[QUOTE="jb1023, post: 1229790, member: 91995"] After I fired off the first few I was thinking they were oblong but when I walked up to check it was just the paper ripping. The paper was not flush with the backing due to the plywood backing splintering from previous trips (100M was plywood backing and 200M was cardboard). The actual holes in the plywood were all round. If I'm hitting 2" low at 100 I would figure about 1-2" below that at 200. I am going to clean my barrel with some wipeout, load up some more rounds and then try again starting at 100 and move my way back to 300yds. Might even be able to get out there this weekend, I hope. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
What could cause a jacket separation for a mid powered load?
Top