Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Vanguard bottom metal problem?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="J E Custom" data-source="post: 947601" data-attributes="member: 2736"><p>It is just for alignment and should go down in the stock allowing the bottom metal to contact the stock inletting.</p><p></p><p>If you pillar bed the stock they can be ground down or contact the pillars at the same time</p><p>the bottom metal contacts the stock. Ether way you want to end up with a metal to metal to</p><p>metal contact(Action to pillar to floor metal) and the action screws floating (Not touching the sides of the pillars).</p><p></p><p>If the bottom of the boss is not square I would probably grind it off if I pillar bedded the rifle.</p><p></p><p>J E CUSTOM</p></blockquote><p></p>
[QUOTE="J E Custom, post: 947601, member: 2736"] It is just for alignment and should go down in the stock allowing the bottom metal to contact the stock inletting. If you pillar bed the stock they can be ground down or contact the pillars at the same time the bottom metal contacts the stock. Ether way you want to end up with a metal to metal to metal contact(Action to pillar to floor metal) and the action screws floating (Not touching the sides of the pillars). If the bottom of the boss is not square I would probably grind it off if I pillar bedded the rifle. J E CUSTOM [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Vanguard bottom metal problem?
Top