Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Chatting and General Stuff
General Discussion
Using 7x57 brass to make 6mm Remington brass
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Hugnot" data-source="post: 2381420" data-attributes="member: 115658"><p>Probably would not take that much effort except I am real fussy. Take a few short cuts, like neck down to 6mm with 6mm F/L die, turn necks, trim & F/F. Turning brass necked down from 7X57 is advised - neck walls will be real thick. Be sure .243 diameter bullets slip fit into fired cases.</p><p></p><p>If I can do it, anybody can do it.</p></blockquote><p></p>
[QUOTE="Hugnot, post: 2381420, member: 115658"] Probably would not take that much effort except I am real fussy. Take a few short cuts, like neck down to 6mm with 6mm F/L die, turn necks, trim & F/F. Turning brass necked down from 7X57 is advised - neck walls will be real thick. Be sure .243 diameter bullets slip fit into fired cases. If I can do it, anybody can do it. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Chatting and General Stuff
General Discussion
Using 7x57 brass to make 6mm Remington brass
Top
