Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Uh oh.... I screwed up
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Ckgworks" data-source="post: 1528102" data-attributes="member: 105102"><p>Take a smaller than hole drill bit and spin BY HAND in the hole......you'll feel right away if its steel or epoxy. If it's epoxy the small hole left will give some room for epoxy to go when you run the screw back down (or use a bottom tap) First do no harm, but I think you can clean this up in a couple minutes.....your front hole should stop on your barrel threads on most guns.</p></blockquote><p></p>
[QUOTE="Ckgworks, post: 1528102, member: 105102"] Take a smaller than hole drill bit and spin BY HAND in the hole......you'll feel right away if its steel or epoxy. If it's epoxy the small hole left will give some room for epoxy to go when you run the screw back down (or use a bottom tap) First do no harm, but I think you can clean this up in a couple minutes.....your front hole should stop on your barrel threads on most guns. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Uh oh.... I screwed up
Top