Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Tuning for long range
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Alex Wheeler" data-source="post: 1356990" data-attributes="member: 101859"><p>I did shoot one group at load 9. I had one shot go low to make the group about 6" but 4 were in 2.25" at 1000. I had one case that was hard to close the bolt on and I bet that was the culprit. This particular barrel is tight, I noticed that when I was chambering it. That upper node will be a little hard on cases and they are not cheap. I decided to shoot the 3100 node. 4 of these all shoot at 3100. This one takes a few grains less to get there as its a little tight. A regular barrel should run the 3150 node without issue.</p></blockquote><p></p>
[QUOTE="Alex Wheeler, post: 1356990, member: 101859"] I did shoot one group at load 9. I had one shot go low to make the group about 6" but 4 were in 2.25" at 1000. I had one case that was hard to close the bolt on and I bet that was the culprit. This particular barrel is tight, I noticed that when I was chambering it. That upper node will be a little hard on cases and they are not cheap. I decided to shoot the 3100 node. 4 of these all shoot at 3100. This one takes a few grains less to get there as its a little tight. A regular barrel should run the 3150 node without issue. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Tuning for long range
Top