Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Trouble with ETips - lack of tension
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="rscott5028" data-source="post: 513726" data-attributes="member: 24624"><p>I had a similar problem some time back using Barnes TTSX due to the relief grooves. Basically, I was partial neck sizing and using almost too little tension with SMKs and then there wasn't enough surface with the TTSXs. </p><p> </p><p>Have you measured your bullet OD and neck ID with your calipers or mic? </p><p> </p><p>The neck should be about .002-.003" smaller than the bullet. </p><p> </p><p>-- richard</p></blockquote><p></p>
[QUOTE="rscott5028, post: 513726, member: 24624"] I had a similar problem some time back using Barnes TTSX due to the relief grooves. Basically, I was partial neck sizing and using almost too little tension with SMKs and then there wasn't enough surface with the TTSXs. Have you measured your bullet OD and neck ID with your calipers or mic? The neck should be about .002-.003" smaller than the bullet. -- richard [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Trouble with ETips - lack of tension
Top