Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
To neck turn, to ream or not to ream?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Alibiiv" data-source="post: 1547376" data-attributes="member: 69192"><p>I like the idea about turning the necks on new brass first before even firing them. From what I am gathering here, good brass makes sense. Before reading this forum, I thought that "brass was brass", now realize that is not the case! There certainly is a lot of information to process about neck sizing, turning and reaming. I currently have the Forster Original trimmer, they too have a neck turning and reaming process that is done at the same time. I'm thinking either Sinclair or K&M and get the entire set up to turn the necks. I am also researching annealing, another process that seems to be technical and challenging equally. I'm starting to think, "just buy the equipment, use it, make mistakes and then ask questions": however, that can get very costly very quickly. I have to thank all of the people on this forum for taking the time and for sharing their experience and knowledge.</p></blockquote><p></p>
[QUOTE="Alibiiv, post: 1547376, member: 69192"] I like the idea about turning the necks on new brass first before even firing them. From what I am gathering here, good brass makes sense. Before reading this forum, I thought that "brass was brass", now realize that is not the case! There certainly is a lot of information to process about neck sizing, turning and reaming. I currently have the Forster Original trimmer, they too have a neck turning and reaming process that is done at the same time. I'm thinking either Sinclair or K&M and get the entire set up to turn the necks. I am also researching annealing, another process that seems to be technical and challenging equally. I'm starting to think, "just buy the equipment, use it, make mistakes and then ask questions": however, that can get very costly very quickly. I have to thank all of the people on this forum for taking the time and for sharing their experience and knowledge. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
To neck turn, to ream or not to ream?
Top