Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Tight chambered 300 RUM fix needed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ken snyder" data-source="post: 627374" data-attributes="member: 26019"><p>Under sized chambers are extremely rare and inadequate head spacing is as well. Die Manufacturers make their dies on the small side unless ordered differently. The problem is almost a guaranteed die set up problem along with trim length and c.o.a l. If the chamber is smooth the only thing you are going to do with a hone is waste your time or ruin the chamber.</p></blockquote><p></p>
[QUOTE="ken snyder, post: 627374, member: 26019"] Under sized chambers are extremely rare and inadequate head spacing is as well. Die Manufacturers make their dies on the small side unless ordered differently. The problem is almost a guaranteed die set up problem along with trim length and c.o.a l. If the chamber is smooth the only thing you are going to do with a hone is waste your time or ruin the chamber. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Tight chambered 300 RUM fix needed
Top