Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
The PRC die "problem"
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="BrentM" data-source="post: 2323599" data-attributes="member: 61747"><p>That is not even remotely accurate. The datum line is just forward of the .0200 on the case. You don't have the tools to measure that accurately. Not many do so most will remove the barrel and do a cast. .533 is likely what it is. AW2 reamer is .535. Your best bet is to get a reamer to keep the proper taper and get dimensions correct. I am holding off using my reamer since I have zero issue with my die or hornady brass so far.</p></blockquote><p></p>
[QUOTE="BrentM, post: 2323599, member: 61747"] That is not even remotely accurate. The datum line is just forward of the .0200 on the case. You don't have the tools to measure that accurately. Not many do so most will remove the barrel and do a cast. .533 is likely what it is. AW2 reamer is .535. Your best bet is to get a reamer to keep the proper taper and get dimensions correct. I am holding off using my reamer since I have zero issue with my die or hornady brass so far. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
The PRC die "problem"
Top