Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
The PRC die "problem"
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="AZShooter" data-source="post: 2029297" data-attributes="member: 5219"><p>Phorwath and I in essence made our own small base dies.</p><p></p><p>I incrementally moved the sizer ring deeper, checking fit of sized brass in the rifle. When there was no resistance to primary camming action when opening the bolt it ending up being enough to work when firing the cartridge. If I were to slightly oversize the base doubt it would ruin the case.</p><p></p><p>You could always sand of some metal from the rear of the chamber.....</p></blockquote><p></p>
[QUOTE="AZShooter, post: 2029297, member: 5219"] Phorwath and I in essence made our own small base dies. I incrementally moved the sizer ring deeper, checking fit of sized brass in the rifle. When there was no resistance to primary camming action when opening the bolt it ending up being enough to work when firing the cartridge. If I were to slightly oversize the base doubt it would ruin the case. You could always sand of some metal from the rear of the chamber..... [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
The PRC die "problem"
Top