Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
The PRC die "problem"
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Wild_Bill" data-source="post: 2027283" data-attributes="member: 4785"><p>A way to help is getting the internals of your FLS die nickel Teflon coated then polished. I have done this on multiple dies to reduce them slightly. However if the dimension you are trying to achieve is smaller than the Web to allow for springbok you will fracture the base of the cases and you will never recover that brass. I have seen new 308 Lapua brass oversized after the first load and it was trash</p><p>Your chamber must be sized correctly for the brass you wish to use and then the die must match the other 2.</p></blockquote><p></p>
[QUOTE="Wild_Bill, post: 2027283, member: 4785"] A way to help is getting the internals of your FLS die nickel Teflon coated then polished. I have done this on multiple dies to reduce them slightly. However if the dimension you are trying to achieve is smaller than the Web to allow for springbok you will fracture the base of the cases and you will never recover that brass. I have seen new 308 Lapua brass oversized after the first load and it was trash Your chamber must be sized correctly for the brass you wish to use and then the die must match the other 2. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
The PRC die "problem"
Top