Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
The PRC die "problem"
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="vancewalker007" data-source="post: 2027199" data-attributes="member: 66917"><p>Yes, and the dies currently available cannot get the base of the case small enough. This happens with the mag cases based on the 375 H&H a lot. Reloading Tech has a die that fixes the orebelt bulge. This is a similar issue. Maybe they'll take of this challenge. My cases that don't fit are running up to .5335 and .534. a virgin Hornady case is usually around .527. The chamber spec is .533, so .0005 is too much.</p></blockquote><p></p>
[QUOTE="vancewalker007, post: 2027199, member: 66917"] Yes, and the dies currently available cannot get the base of the case small enough. This happens with the mag cases based on the 375 H&H a lot. Reloading Tech has a die that fixes the orebelt bulge. This is a similar issue. Maybe they'll take of this challenge. My cases that don't fit are running up to .5335 and .534. a virgin Hornady case is usually around .527. The chamber spec is .533, so .0005 is too much. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
The PRC die "problem"
Top