Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
The 1st thing when building a load.....
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Coyboy" data-source="post: 519615" data-attributes="member: 3733"><p>So do you recomend your "system" for factory chambers only, custom match chambers, or everything?</p><p></p><p>If half the bearing surface of a bullet is surounded by a steel cylinder that is </p><p>.0004" larger in diameter than the bullet diameter, and that portion of the bullet that is surounded by the steel cylinder is .250" long, how much "yaw" is in the bullet, in relationship to the cylinder? assuming the bullet is tipped in that cylinder to make contact opposite each end at both extreames, then measuring "yaw" relative to the center of the bullet in the cylinder to the bullets tip. On a 142 smk.</p><p></p><p>Because after all your claiming your way of doing it straightens things out to prevent yaw I'm just curious how much of what we are straightening exists.</p></blockquote><p></p>
[QUOTE="Coyboy, post: 519615, member: 3733"] So do you recomend your "system" for factory chambers only, custom match chambers, or everything? If half the bearing surface of a bullet is surounded by a steel cylinder that is .0004" larger in diameter than the bullet diameter, and that portion of the bullet that is surounded by the steel cylinder is .250" long, how much "yaw" is in the bullet, in relationship to the cylinder? assuming the bullet is tipped in that cylinder to make contact opposite each end at both extreames, then measuring "yaw" relative to the center of the bullet in the cylinder to the bullets tip. On a 142 smk. Because after all your claiming your way of doing it straightens things out to prevent yaw I'm just curious how much of what we are straightening exists. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
The 1st thing when building a load.....
Top