Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Switching bullets effecting zero?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="IHFarmer07" data-source="post: 1902525" data-attributes="member: 75397"><p>Been there done that the other day, I have been shooting 147eldms in my 6.5prc for a while but the other day I got the federal 130 terminal ascent bullet and I started to do load development without cleaning the barrel completely.......I found out that I'm going to have to do this above^^^^^my velocities where higher than advertised but everything seemed fine otherwise, although there was a time or two where my pressure obviously was on the edge because I was getting that extra "click" ppl talk about when extracting the case, (so keep in mind for safety sakes, clean your barrel before switching bullets), now back on topic, so I loaded more in my "nodes" and my velocity's where way down from where they should've been in the powder charge, so [USER=98068]@Winkfish[/USER] is on the money, I've heard about this before just never seen this personally.......they say the same for changing powders and primers also but I think I'd just remove powder fouling for those, I think, idk, I guess when in doubt, clean.</p></blockquote><p></p>
[QUOTE="IHFarmer07, post: 1902525, member: 75397"] Been there done that the other day, I have been shooting 147eldms in my 6.5prc for a while but the other day I got the federal 130 terminal ascent bullet and I started to do load development without cleaning the barrel completely.......I found out that I’m going to have to do this above^^^^^my velocities where higher than advertised but everything seemed fine otherwise, although there was a time or two where my pressure obviously was on the edge because I was getting that extra “click” ppl talk about when extracting the case, (so keep in mind for safety sakes, clean your barrel before switching bullets), now back on topic, so I loaded more in my “nodes” and my velocity’s where way down from where they should’ve been in the powder charge, so [USER=98068]@Winkfish[/USER] is on the money, I’ve heard about this before just never seen this personally.......they say the same for changing powders and primers also but I think I’d just remove powder fouling for those, I think, idk, I guess when in doubt, clean. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Switching bullets effecting zero?
Top