Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Photography
Gun Photos
Stubby .308 for hunting
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="T3ninja" data-source="post: 1360585" data-attributes="member: 95079"><p>Just thought I'd throw this pic up here. This was a Friday night project for a lightweight deer rifle. I used a .223 with a cheapo plastic stock that I stiffened up for a donor and the bolt out of my other .308. I have a heavy barreled (almost 20lbs) .308 for general shooting and long range, but the 28" barrel sucks up in a tree stand. Not to mention, where I'm hunting 300 yards is a long shot. </p><p> So a member on here made me a deal I couldn't refuse. I got the barrel, measured it up and chopped it off with a hacksaw. Then I smoothed out the cut with a file and finished it off nice and smooth (going to hit it again with a finer grit) with sandpaper. Then I used an old Lee case trimmer to cut a recess for the crown. Doing this also made sure that the cut was square to the bore. I finished off the crown by using a Lyman case chamfer tool and polished it up with a brass drew and some case polish. This put the finished naked rifle (no scope/ bipod) just over 5 lbs. </p><p></p><p> All this might sound like insanity to most, including me. But after putting about 30 rounds through it and ZERO load development for this barrel it is giving me sub MOA out to 200 yds using stuff I've loaded for the other rifle. </p><p></p><p>Specs </p><p>.223 savage model 11 receiver and stock. </p><p>Model 10 savage .308 bolt </p><p>Model 10 lightweight barrel cut to 16.75"</p></blockquote><p></p>
[QUOTE="T3ninja, post: 1360585, member: 95079"] Just thought I'd throw this pic up here. This was a Friday night project for a lightweight deer rifle. I used a .223 with a cheapo plastic stock that I stiffened up for a donor and the bolt out of my other .308. I have a heavy barreled (almost 20lbs) .308 for general shooting and long range, but the 28" barrel sucks up in a tree stand. Not to mention, where I'm hunting 300 yards is a long shot. So a member on here made me a deal I couldn't refuse. I got the barrel, measured it up and chopped it off with a hacksaw. Then I smoothed out the cut with a file and finished it off nice and smooth (going to hit it again with a finer grit) with sandpaper. Then I used an old Lee case trimmer to cut a recess for the crown. Doing this also made sure that the cut was square to the bore. I finished off the crown by using a Lyman case chamfer tool and polished it up with a brass drew and some case polish. This put the finished naked rifle (no scope/ bipod) just over 5 lbs. All this might sound like insanity to most, including me. But after putting about 30 rounds through it and ZERO load development for this barrel it is giving me sub MOA out to 200 yds using stuff I've loaded for the other rifle. Specs .223 savage model 11 receiver and stock. Model 10 savage .308 bolt Model 10 lightweight barrel cut to 16.75" [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Photography
Gun Photos
Stubby .308 for hunting
Top