Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Small Base Die - Worth the Money?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="AZShooter" data-source="post: 2009030" data-attributes="member: 5219"><p>It was over ten years ago. I just went out and measured what the 338 RCM length is now. 1.850" </p><p>I cut off at least 1/2" from bottom. I figured I could slowly adjust it down till it sized the bottom enough. I had stiff bolt closure and when the die was properly adjusted the bolt closed easily. </p><p></p><p>I would say set it up and try it. Fire some small base sized rounds and see how the bolt lifts. Adjust as necessary. You can paint some layout fluid on case and see where it is reducing the diameter. All I know is that it works.</p></blockquote><p></p>
[QUOTE="AZShooter, post: 2009030, member: 5219"] It was over ten years ago. I just went out and measured what the 338 RCM length is now. 1.850" I cut off at least 1/2" from bottom. I figured I could slowly adjust it down till it sized the bottom enough. I had stiff bolt closure and when the die was properly adjusted the bolt closed easily. I would say set it up and try it. Fire some small base sized rounds and see how the bolt lifts. Adjust as necessary. You can paint some layout fluid on case and see where it is reducing the diameter. All I know is that it works. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Small Base Die - Worth the Money?
Top