Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Sizeing without expander ball
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MagMan" data-source="post: 266434" data-attributes="member: 966"><p>If you take a case with unacceptable neck run out and size with a bushing neck die the run out won't get any better. There is nothing to hold the body in place while the bushing sizes the neck to the proper size and location. The neck will be the proper size but will remain off center of the body. To much floating going on to straighten anything out, which is the way it was designed to work I believe.</p><p></p><p>As I have stated the FL bushing die may work but I'm not willing to spend the money on that when I could have a custom die made to my specific neck size.</p><p></p><p>I have also noticed brass with good run out wont get any worse when being run through a bushing die. It just never gets any better in my case though I'm sure some will disagree.</p></blockquote><p></p>
[QUOTE="MagMan, post: 266434, member: 966"] If you take a case with unacceptable neck run out and size with a bushing neck die the run out won't get any better. There is nothing to hold the body in place while the bushing sizes the neck to the proper size and location. The neck will be the proper size but will remain off center of the body. To much floating going on to straighten anything out, which is the way it was designed to work I believe. As I have stated the FL bushing die may work but I'm not willing to spend the money on that when I could have a custom die made to my specific neck size. I have also noticed brass with good run out wont get any worse when being run through a bushing die. It just never gets any better in my case though I'm sure some will disagree. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Sizeing without expander ball
Top