Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Sinclair Concentricity Gauge
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="6pakzak" data-source="post: 2378502" data-attributes="member: 120986"><p>[ATTACH=full]323331[/ATTACH]check this out, after putting mica on shell plate holder with good results I thought maybe little burr on base of shell might be causing slight tilt in case or maybe digging in to shell holder cause I had to remove crimp ring on cases, lightly spun base by hand on 1000 grit sandpaper and you can see little bits of brass left behind, went back to sizing and runout is even lower on case, close to nothing on many</p></blockquote><p></p>
[QUOTE="6pakzak, post: 2378502, member: 120986"] [ATTACH type="full"]323331[/ATTACH]check this out, after putting mica on shell plate holder with good results I thought maybe little burr on base of shell might be causing slight tilt in case or maybe digging in to shell holder cause I had to remove crimp ring on cases, lightly spun base by hand on 1000 grit sandpaper and you can see little bits of brass left behind, went back to sizing and runout is even lower on case, close to nothing on many [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Sinclair Concentricity Gauge
Top